Preparations For CNC Maintenance Of CNC System Of CNC Machine T

  • (1) Data replication

    When the machine tool factory is handed over to i-Japan, it should copy the final set machine data, part processing subroutines, and PLC programs to the user, in order to restore the machine tool when the battery loses power or the flash memory is confused. At the maintenance site, we often encounter the phenomenon of lack of the above-mentioned technical data, so we cannot carry out the work. The machine tool cannot be recovered for a long time, causing great losses to users. Sometimes the data that the machine tool factory gives to the user is printed after the first adjustment, but the data is modified in the second adjustment, but the modification record is not handed over to the user. Therefore, it is best for the user to make a copy of the data when the machine tool is working normally.

    (2) Replace the battery

    The CNC system generally has only one battery box, which is fixed on the bottom right wall of the main box, and the battery box cover is located on the right side of the 40A power board. Early use is a C-type kangpo battery, 3.6V.The later use is three AA type high-energy batteries, 4.5V, normal
    In all cases they can be used for 5 years. When the voltage drops to 2.7V, the system will issue an alarm No. 1. If the voltage is lower than 2.7V, the data will be lost. The BAU alarm is visible from the interrupt stack. So don’t cut off the power again when you find the alarm of No. I. Wait until the battery is replaced before shutting down.

    (3) Due to the unstable voltage of the domestic power grid

    sometimes the machine tool factory requires the user to install a voltage stabilizer.
    If only to stabilize the numerical control power supply voltage, a purified power supply can be used. It can stabilize voltage and suppress higher harmonics. Large voltage regulators must be used for the entire machine. At present, there are two main types of domestic production, self-disaster type and magnetic adjustment type. When the voltage fluctuates frequently, the magnetic adjustment type should be used, because this equipment adjusts smoothly and has no high-order harmonic output.

    (4) The designed working environment temperature

    The designed working environment temperature of Siemens CNC system is lower than 45°C
    If the ambient temperature is too high or the heat dissipation conditions are not good, it will cause an alarm, and an air conditioner should be installed. But the most harmful to the CNC system is humidity. Conventional wisdom holds that wet environments tend to short circuit boards. But in practice, it is also common to see open circuits caused by oxidation of solder joints caused by electrolysis or other reasons.

    At Be-cu.com,we use advanced equipment to offer you Unparalleled precision for producing metal and plastic machining parts

    • We combine the latest CNC milling and turning processes with proprietary technology to deliver high quality, on-demand parts.
    • Our team of engineers and machinists program the equipment to optimize cutting time, surface finish, and final tolerance to meet your design specifications
    • We specialize in cnc precision machining, single part prototyping, short to medium production runs, manufacture parts on time, every time, so you can stay ahead of schedule
    • CNC machining can create very similar parts to series parts. It is often more efficient and faster than other rapid prototyping technologies for the manufacture of a quantity of prototypes between 1 and 10 parts . We also recommend CNC machining for parts with large sizes (greater than 600 mm).